compliments: www.mototuning.ch

GSF1200 Bandit 1200
96-00 and 01-07

using
 90-92 gsxr750 38mm carbs

 

"Long Boy" Extended Fuel Screws


Long Boy Extended Fuel Screw set  $89.95

Factory Pro pn: 5020M
for 90-92 38mm gsxr750 carbs

 with 4 new screws, springs, washers and o-rings

1. Choose your shipping method

2.

 

"Long Boy"        

    Finger adj. extended Fuel Screw Kit

Frustrated with trying to find an "almost 90 degree"  screwdriver to fine adjust your fuel screws for best idle and cruise?
Use Factory Pro's new "finger adjustable" fuel screws to adjust fuel screws for best throttle response. Traveling to high altitude? It's easy to lean out the lowend temporarily. Knurled for easy finger adjust for weather or altitude or highway cruising mileage
Straight knurled for pushing with a flat bladed screwdriver if your hand doesn't fit.
Screwdriver slotted for if you want to use a short or right angled screwdriver (so a shop mechanic is happy)

Make your life easier.

Installation:
Remove old short stock fuel screws, old o-rings, old washers and old spring. The o-ring might be stuck in the carb, so, take a light and make sure it's really out if it didn't come out with the screw (or you can't find it after you took out the screw)
Use a small bent wire to pull it out if it doesn't drop out. Keep the old parts for "spares".

New fuel screw kit comes with:
4 Long Boy fuel screws
 4 new o-ring
4 new washer
4 new spring

Carb Recalibration Kits / Jetting kits

CRB-S21-3.0
  $149.95
(uses  2922 filters - not included)
**38mm gsxr750 carbs**
1. Choose your shipping method
2.
 

Config 30 carb kit

1100cc / 38mm "750" carb conversion

Have a set of 90-92,  38mm  GSX-R750 carbs? Want to run them on the 1100/1200? Use this 3.0 kit and matching 2922 BMC or K&N air filters.
Note: When procuring 750 carbs, make sure that you get carbs from an air cooled 750. The carb spacing is different on the water cooled 750's.
Note! When replacing a dj kit with Factory Pro components, be sure to replace the emulsion tubes with stock, Suzuki tubes (available from Suzuki). The dynojet emulsion tubes will not work with Suzuki or Factory Pro needles. The Mikuni emulsion tubes have ID numbers and the dynojet tubes are not marked with any part number.

Note:
It's possible that the water cooled 750 carbs will fit onto the air cooled 1100 and 1200 engines. You need to use an additional set of 1100
"inside" intake rubbers and put them on the outside cylinders. This is just something that someone told me - I would try with your 2-3 stacks mounted on 1-4 cylinders first.

 

Shift Improvement Kits

Detent Arm REBUILD / UPGRADE SERVICE
for stock Suzuki detent arm #25350-27A10

Replace worn stock roller with new F-Pro Microbearing assembly

$49.95 for standard microbearing
$79.95 for Hybrid Ceramic microbearing.

Call Factory Direct 415 883-5620
M-F 9-5 Los Angeles time
or
marc@factorypro.com

SHFT-SUZ-PRO-3     $139.95

microbearing detent arm and spring kit

1. Choose your shipping method

2.

Trans Detent Arm Pro Shift Kit

 Includes New Factory Pro Spring, new Factory Pro Microbearing Detent Arm and oil pan gasket.

Make shifting MUCH quicker and virtually eliminate missed shifts.  Shifts easier and quicker than the standard shift kit.

Helps prevent shift fork and gear engagement dog damage caused by missed shifts.

Tools : diagnostic and setting

TL-float height gauge $59.95

1. Choose your shipping method

2.

The only way to accurately measure float heights. Works on nearly every carburetor.

.

These products were developed on the same EC997a Eddy Current dyno that developed the K59-1.7-RK ZX-6R RaceKit (Muzzy and Kinko's choice), the Y73-1.7-RK YZF750 (Vance and Hines choice), S37-1.7-RK GSX-R750 x, Suzuki of France and most of America's privateer racers choice)...

Sounds of Dyno Test

EC997 Eddy Current Dyno
Moderate load Test,
recorded at Factory Pro

Factory Pro
C10 Bandit 1200
w/ VHR SS2r street

Free download
-EC997 Dyno sounds-
click here

 

Actual Screen on EC997 Eddy Current Dyno

  • Base Test.........all stock carburetion and stock exhaust system
  • Bolt on exh......Yosh Race Slip-on, CRB-S74-1.0 - Carb Kit
  • Final.................Yosh Race Slip-on, CRB-S74-1.0 - Shows carb kit and +5 advance power improvement!
    • Notice the power increase throughout the entire powerband at full throttle. We recomended RTR-SUZ-4 (+3)!

S74 Config 10 Dyno Chart

True Rear Wheel HP scale


 

Absolutely NO carb parts sold in California.

New and improved Suzuki Teka SFI  2

with new TPS display and "MMT" Memory Module Tuner

Finally - Quick, easy, cost effective Suzuki tuning with no expensive "add-on boxes"
Suzuki cruisers and sportbikes

Please click here for more info

Contact Factory Pro
M-F, 9am - 5pm, Pacific time, -7 or -8 GMT

800 869-0497
 USA and Canada

415 883-5620

parts information
 info@factorypro.com

EC997 dynamometer information
info@factorypro.com

Product Support /Tech SECTION
click here

 

Mailing / Shipping address:

Factory Pro
101c Roblar Drive
Novato, CA
USA

And most importantly
Restart back at the HOME page and click on the red box in the top left to find the bike that you want parts for...
restart at HOME page

 

This Tuning Site has been visited by
  
people.
www.digits.net - the oldest counting service on the web

          

 

 

 

LINKS
EFI and Carb Tuning - Most all FI and carb tuning

by Wheelsmith Racing

Flight Training - train with AMA race winner Todd Harrington.

The Harringtons own American Flyers, one of the most established flight training facilities in the USA.

 8 locations

 800-362-0808
The Rich Oliver Mystery School will help you discover your hidden inner strength. 
It will challenge you. It will teach you a new way of thinking, and a new way of riding. You can take your riding to an exciting new level!  

We use a variety of proven drills and training techniques. 
Practicing these techniques with our Yamaha dirt track trainers will enhance your abilities both on the track or the street.  

It doesn't matter what you ride or race, the Rich Oliver Mystery School improves everyone's skill level and mindset!

WW2 vintage flying Special

Book a sightseeing flight over the Wine Country or a Kamikaze aerobatic flight or a biplane flight over famous Sonoma Raceway, the Golden Gate Bridge and the San Francisco Bay for one or two during the spring and get a free souvenir t shirt!
(NEW!  Ask about the P-40 flights!)

707 938 2444

Just tell them that you saw this on the Factory Pro website!
Marc
Northern California's most unforgettable flying experience.  No experience required.  Open weekends!

The extension of the laboratory for engines of the Swiss Federal Institute of Technology was completed in about 1935. Its architect was Rudolf Otto Salvisberg (1882-1940). He had a successful career in Berlin but returned to Switzerland after the advent of the Nazis. His architectural style was somewhat similar to that of Erich Mendelsohn. The staircase of the laboratory is in normal use but well preserved.
Edited to the tunes of Chemical Residue by Herbie Hancock.